Last Updated: 16 November 2026

Quick Summary

If a building inspection finds major defects, you still have options, but you must act within your contract deadlines. Major defects are faults affecting a property’s structure, safety or long-term value, so verify them with a specialist, obtain written repair quotes and then decide whether to negotiate, wait or walk away.

  • Read the full report and note every item the inspector marked as major.
  • Check your contract conditions and deadlines before taking any other step.
  • Get a specialist report where the defect involves structure, safety or water ingress.
  • Obtain at least two or three written quotes scoped to the same description of work.
  • Not every property deserves an offer, and sometimes walking away is the best advice.

Table of Contents

If a building inspection turns up a major defect, your offer is not dead, but you need to act fast and stay in control. Major defects are the single biggest reason a Melbourne purchase goes sideways after the contract is signed. Knowing your options before the report lands separates the buyer who negotiates a sensible outcome from the one who panics and overpays.

What Counts as a Major Defect in a Building Inspection

A major defect is a fault that affects the structure, safety or long-term value of a property, more than a cosmetic problem or maintenance item. Inspectors use the term to flag issues that could be costly to fix and that a buyer would not reasonably accept without a change to price or conditions.

How to Negotiate a Lower House Price in Melbourne
How to Negotiate a Lower House Price in Melbourne

Major defects usually fall into a few groups:

  • Structural problems: foundation movement, sagging floors, failing footings
  • Water issues: roof leaks, rising damp, moisture ingress
  • Safety concerns: unsafe wiring, a failing staircase, a dangerous balcony

Examples: cracking, movement, roof leaks and water damage

Not every crack is a problem. If you’re unsure how to separate serious findings from routine notes in a dense report, this guide walks through it. Hairline plaster cracks are usually cosmetic.

A buyer may spot a crack and assume the worst, or dismiss one that deserves a closer look. A rough guide:

  • Stepped cracks in brickwork, or cracks wider than a few millimetres, can signal foundation movement
  • Doors and windows that stick may point to structural shift
  • Water stains on ceilings often mean an active roof leak, not an old one

A competent inspector will describe what they see, but they cannot always tell you the cause. That is when a specialist assessment, such as from a structural engineer, becomes essential before you commit.

Major versus minor defects: where buyers get it wrong

This is where most buyers stumble. A minor defect, like a dripping tap or worn carpet, is a negotiation point at best. A major defect can change the whole deal.

A serious structural issue can be mistaken for a minor fix when the vendor describes it as “just cosmetic.” Verify the severity independently, and ask the inspector to explain the likely cause and scope of repair.

What to Do After a Failed Building Inspection

A failed inspection is not a failed purchase, it is a signal to pause and decide on facts. Before your next purchase, see how to prepare properly for a pre-purchase building inspection so you avoid another major defect surprise.

Do not panic and do not ignore it. Work through these steps:

  • Read the full report, not just the summary. Note every item the inspector marked as major.
  • Get a second opinion from a qualified specialist if the issue is structural or unclear.
  • Obtain repair quotes from licensed tradespeople so you know the real cost.

The right move depends on the cost, the risk and what the vendor is willing to do. Buyers who rush this stage tend to pay more than they should.

Once the report lands, work through these steps in order so you decide on facts rather than panic.

StepWhat to doTime or frequency
Read the reportRead the full report, not just the summary, and note every major itemStraight away
Get a second opinionConsult a qualified specialist if the issue is structural or unclearBefore you respond
Obtain repair quotesGet quotes from licensed tradespeople to learn the real costWithin your contract window
Check contract conditionsReview the inspection clause and other conditions before actingBefore any other step
Decide your positionRequest repairs, negotiate the price or walk awayBefore contract deadlines

Checking Your Contract: Cooling-Off Period and Inspection Clause Deadlines

Your contract is your protection, and its deadlines are strict. But here’s what most buyers don’t see: your options are not the same at every stage of the deal. The advice from a friend who bought last year may be completely wrong for where you sit right now.

Work out which stage you are in before you do anything else.

Stage 1: Before you sign

This is the strongest position you will ever have. You can walk away for any reason, or no reason, and it costs you nothing but time.

  • Get the inspection done before you sign wherever possible, especially on older Melbourne stock, period homes in the inner north and east, and 1960s-1970s brick veneer in the middle ring, are where structural surprises live.
  • Read the contract before the inspection lands, not after. Know whether it is a standard form with a building inspection clause, or a vendor-drafted contract where that clause has been removed.
  • Ask your conveyancer to flag every condition and deadline in writing, with dates, before you sign anything.

A private sale contract can be presented as “standard” when the building inspection clause has been struck out. If you sign without checking, you may have no contractual right to act on a bad report.

Stage 2: During a conditional period or cooling-off

This is where most of the money is won and lost, and where deadlines are unforgiving.

  • The cooling-off period gives you a short window to change your mind after signing. In Victoria, a standard contract of sale for residential property typically includes a cooling-off period, but the length and any exceptions (for example, purchases at auction or certain off-the-plan arrangements) must be confirmed for your specific contract. Consumer Affairs Victoria publishes current guidance, read it, then confirm with your conveyancer.
  • A building inspection clause usually lets you terminate, renegotiate or require repairs if the report is unsatisfactory, but only if you act within the stated time. The clause often requires written notice, not a phone call to the agent.
  • Finance and other conditions run on their own clocks. A building inspection deadline and a finance deadline can fall on different days, and missing either can cost you your deposit or your right to exit.

A practical checklist for this stage:

  1. Diarise every deadline the day you sign, with a reminder several days before each one.
  2. Confirm in writing with your conveyancer what notice is required and to whom.
  3. Keep every email, text and letter with the agent, vendor and inspector in one folder.
  4. Do not rely on a verbal assurance from the agent that “the vendor will fix it”, get it in the contract or in writing.

Stage 3: After the conditional period ends or after settlement

Once the conditional period has passed, or once you have settled, your leverage changes completely.

  • Statutory warranties may apply to certain residential building work under Victorian domestic building law, but they depend on the age of the work, who did it and whether a permit was required. Confirm the position with your conveyancer or legal adviser.
  • Building permits and occupancy certificates can be checked with the relevant council. Unpermitted work is a common and expensive discovery.
  • Insurance may or may not respond to a defect discovered after settlement. Check the policy wording before you assume you are covered.

The time to use your leverage is before the conditional period closes, not after. Once settlement has passed, the same options generally no longer apply.

Rules, deadlines and clause wording change, and they differ between contracts. Always confirm the current position for your specific contract with your conveyancer or solicitor before you act.

Negotiating the Price After a Building Inspection

A major defect gives you real leverage, provided you use it well. Read about what separates a buyer who wins a price reduction from one who simply loses the deal.

A negotiation built on a one-line summary from the inspector and a guess at the repair cost is easily picked apart. Our Property Negotiation Service Melbourne is built around putting that evidence and process in place before the first offer goes in.

Step 1: Verify and scope the defect before you negotiate

An inspection report describes symptoms. It is not a repair specification and not a quote. Before you put a number to the vendor, you need to know what you are actually dealing with.

  • Separate observed symptoms from confirmed structural issues. A crack is a symptom. Foundation movement is a diagnosis. Only a specialist, usually a structural engineer for footings, load-bearing walls and roof structure, can confirm the cause and extent.
  • Ask the inspector to clarify anything vague in the report, in writing, before you rely on it.
  • Get a specialist report where the defect involves structure, safety or water ingress. This costs money, but it is the difference between a negotiation built on evidence and one built on guesswork.

Step 2: Build a cost picture from comparable written quotes

Do not treat the inspector’s estimate as the repair cost. Get at least two, ideally three, written quotes from licensed tradespeople, each scoped to the same description of work so they can be compared.

  • Scope the work in writing and give the same brief to every tradesperson.
  • Allow for further investigation. Structural repairs often reveal more once walls are opened. A quote that assumes the best case is not a reliable basis for negotiation.
  • Separate immediate safety work from longer-term rectification. The vendor may agree to one and not the other.

Watch out: a single cheap quote is not evidence. Vendors and their agents know a low quote when they see one, and it undermines your credibility for the rest of the negotiation.

Step 3: Compare the property to recent sales in its current condition

This is where comparable sales data matters most. A vendor is more likely to accept a reduction when you can show, with evidence, what similar homes in the area have sold for in comparable condition. Our Property Due Diligence work covers this kind of sales analysis in detail.

  • Use like-for-like sales, same suburb, similar land size, similar age and condition, recent enough to be relevant.
  • Adjust for condition, not just location. A renovated comparable is not the same as a home with a structural defect.
  • Present the evidence clearly, not as a demand. A short, reasoned summary beats a long argument.

Step 4: Run the negotiation as a documented process

The buyer who controls the paperwork controls the outcome.

  1. Put your position in writing to the agent, with the defect, the specialist findings, the quotes and the adjustment you are seeking.
  2. Offer options, a price reduction, a repair allowance or a credit at settlement, so the vendor has a path to yes.
  3. Set a clear response deadline that sits inside your contract deadlines, not outside them.
  4. Keep a record of every communication: date, time, who said what, and what was agreed.
  5. Get any agreement varied into the contract by your conveyancer, not left as a verbal promise.

Sample questions to put to the agent in writing:

  • “Has the vendor obtained their own specialist report on this defect? Can it be provided?”
  • “Will the vendor consider a repair allowance at settlement rather than a price reduction?”
  • “What is the vendor’s position on completing the works before settlement, with evidence of completion?”

Step 5: Decide when to negotiate hard, wait or walk away

The property may look right. The numbers still need to stack up.

  • Negotiate hard when the defect is significant, the repair cost is clear and evidenced, and the property still makes sense at a lower price.
  • Wait when you need a specialist report or a clearer quote before you commit to a position, but only if your contract deadlines allow it.
  • Walk away when the cost, the risk or the uncertainty outweighs the value of the property.

Not every property deserves an offer. Sometimes the best advice is to walk away, and that decision protects far more money than a clever negotiation ever will.

A short hypothetical example: a buyer receives a report flagging stepped brickwork cracking and a sagging floor in an older inner-north home.

Getting a Second Opinion on a Major Defect

A second opinion protects you from two mistakes: overreacting to a problem that is less serious than it looks, or underreacting to one that is far worse.

Benefits of Using a Buyers Agent for First Home Buyers
Benefits of Using a Buyers Agent for First Home Buyers

Consider a second opinion when:

  • The inspector’s report is vague about the cause or extent of the defect
  • The estimated repair cost varies widely between quotes
  • The defect involves the foundations, footings, load-bearing walls or the roof structure

A structural engineer is usually the right specialist for foundation and cracking concerns. Their report gives you a far clearer picture of what the defect means, and stronger ground in any negotiation.

Risk vs. Strategy: When to Negotiate Hard, Wait or Walk Away

The property may look right. The numbers still need to stack up.

Every major defect forces one of three decisions:

  • Negotiate hard when the defect is significant, the repair cost is clear, and the property still makes sense at a lower price.
  • Wait when you need more information, such as a specialist report or a clearer repair quote, before you commit to a position.
  • Walk away when the cost, the risk or the uncertainty outweighs the value of the property.

Not every property deserves an offer. Sometimes the best advice is to walk away, and that decision protects far more money than a clever negotiation ever will.

Booking Your Strategy Session Before You Make the Next Move

If you have received a building inspection report that flags major defects, the next decision matters. Getting independent, experienced advice at this stage can protect your deposit, your budget and your position.

At Your Australian Property Buyers Agents, we represent the buyer only.

BOOK A FREE STRATEGY CALL and let us help you decide whether to negotiate, wait or walk away.

Frequently Asked Questions

What should I do if a building inspection finds major defects?

Don’t panic and don’t sign anything yet. Read the full report, separate the genuine structural or water-related issues from cosmetic wear, and get quotes from licensed trades for the items that worry you. Then decide whether to request repairs, negotiate a lower price, or withdraw from the contract within the time frames set by your contract. Acting within those deadlines is what keeps your options open, so check them the day the report lands.

Can I pull out of a property purchase after a building inspection?

Often yes, but only if your contract includes a building inspection clause and you act before it expires. In Victoria, most residential contracts sold through a private treaty include a finance and building inspection condition, and a satisfactory report or a notice in time lets you withdraw. Once that condition lapses or you waive it, walking away can cost you the deposit, so speak to a conveyancer before the deadline.

Can I negotiate the purchase price after a building inspection?

Yes, and this is one of the most common outcomes when a report flags serious issues. Use the inspector’s findings and the repair quotes to put a dollar figure on the work, then ask for a reduction that covers the repairs plus a margin for risk. Comparable sales in the area show whether the asking price already reflects the condition, so bring that evidence into the conversation rather than negotiating on feel.

How do I get a second opinion on a major building defect?

Engage a different licensed building inspector, or where the issue is structural such as footings, significant cracking or movement, a structural engineer. Ask for a written scope and an independent assessment of the same defect. A second opinion can confirm the severity, reduce the risk of overestimating repair costs, or reveal that the first report overstated the problem, which strengthens your negotiating position either way.